1. The correct selection of the iron remover must also consider the iron content of the material, the requirements for iron removal, the use environment and the characteristics of the iron remover itself.
2. When the material contains a lot of iron, the self-unloading electromagnetic and permanent magnet iron remover with continuous iron-unloading capability (RCDC, RCDD, RCDF, RCYC, RCT, CFLT series) should be selected.
3. When the material contains less iron, it is advisable to use manual iron unloading electromagnetic and permanent magnet iron removers (RCDA, RCDB, RCDE and RCY series). Appropriately lowering the suspension height is conducive to iron removal.
4. When the dust in the use environment is serious, the iron remover with fully enclosed structure should be selected, such as RCDB, RCDZ, RCDE, RCDD, RCDF series electromagnetic products and RCYB, RCYD series permanent magnet products.
5. When the power capacity is limited, a permanent magnet separator should be used.
6. When the iron remover is installed on the head of the belt conveyor, it is beneficial to remove iron because the material has a forward momentum and is in a loose state, but the driving wheel at the bottom of the iron remover should be non-ferromagnetic material.
7. When the iron remover is installed in the middle of the belt conveyor (that is, cross-arranged), in order to improve the iron removal effect, WCG series non-magnetic linear idlers can be added under the belt.
8. For non-ferromagnetic metal materials that cannot be adsorbed by the iron remover, it is advisable to use GJT (JYG) series metal detectors for detection, and manually pick them out after alarm and shutdown.
9. The iron remover has the following characteristics: sucking large and long is easy to small and short; sucking tip is easy to ball; sucking is easy to static. For occasions with high requirements for iron removal, the specifications of the iron remover should be appropriately increased or multi-stage iron removal should be adopted.
10. When using multi-stage iron removal, the iron removal suction of the latter stage should be higher than the iron removal suction of the previous stage, otherwise, the iron removal effect of the latter stage iron remover will be poor.
11. When the material contains very few iron parts, the GJT (JYG) series metal detector is used in conjunction with the powerful magnetic self-unloading electromagnetic iron remover, which saves electricity and saves energy and has a good iron removal effect.
12. There are many ways to remove iron from magnetic materials. If the situation is complicated, you should contact the technical department of our company. Our company can make special designs according to the special purposes and special environments of users.